A permanently lit ABS light on your L200 VI usually points to a wheel speed sensor, its wiring or a dirty tone ring.
Here is what to check first, and whether it is safe to keep driving.
Why Your L200 ABS Light Stays On
On the Mitsubishi L200 VI (the 2015-on Triton), the ABS light runs a self-test each time you start up and then goes out. If it stays lit, the ABS control unit has found a fault and, in most cases, has switched the anti-lock function off to protect itself. A steady light is almost always a stored fault code waiting to be read, and on this generation of L200 the most common culprit by far is a wheel speed sensor or the wiring that feeds it.
These trucks work hard. Mud, grit, water crossings, pressure washing and heavy loads punish the parts that live right next to the wheels. The front sensor harness runs down near the strut and wheel arch where it can rub through or take a hit from debris, and the rear sensors sit on the axle, constantly exposed to dirt and water. A corroded connector, a sensor tip packed with metal filings, a cracked or rusted tone ring, or wheel bearing play that changes the air gap will all trigger the same warning. Less common causes include low brake fluid, a blown ABS fuse, low battery voltage while cranking, a poor earth, or a failing ABS pump or module — which is exactly why reading the codes beats guessing and swapping parts.